Lubrication Points; Driveline Constant Velocity Shaft; Driveline Shafts; Inner Tube Of Driveline - Land Pride AFM4214 Operator's Manual

Land Pride
Section 5: Maintenance & Lubrication

Lubrication Points

Lubrication
Legend
12/06/11
Table of Contents
Multi-purpose
spray lube
12726
13667
Inner Tube
12729
Multi-purpose Multi-purpose
grease lube oil lube

Driveline Constant Velocity Shaft

Type of Lubrication: Multi-purpose Grease
Quantity = See drawing
IMPORTANT: Extensive lubrication must be
performed every 8 hours of operation to extend the
life of the constant velocity joint!
•
Grease constant velocity joint in a straight position
to force grease through its passages and into the
cavity. Grease should be visible around ball joints.
•
Grease fittings in the outer telescoping member,
u-joints and driveline shields every 8 hours of
operation to prevent premature break down.

Driveline Shafts

Type of Lubrication: Multi-purpose Grease
Quantity = See drawing

Inner Tube of Driveline

Type of Lubrication: Wheel Bearing Grease
Clean and coat all inner tubes of the Drivelines with a light
film of grease and then reassemble.
AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M
Intervals in hours
50
at which lubrication
is required
8
Hours
25
Hours
50
Hours
29