Option
Auto On Time
USB Wake Support
Wireless Radio Control
Wake on LAN/WLAN
Block Sleep
Peak Shift
Advanced Battery Charge
Configuration
Primary Battery
Configuration
Description
•
Wake on AC
Allows you to set the time at which the computer must turn on
automatically. The options are:
•
Disabled (Default Setting)
•
Every Day
•
Weekdays
•
Select Days
Allows you to enable the USB devices to wake the computer from
standby mode. The option is disabled
•
Enable USB Wake Support
Allows you to control the WLAN and WWAN radio. The options are:
•
Control WLAN radio
•
Control WWAN radio
Default Setting: Both the options are disabled.
This option allows the computer to power up from the off state when
triggered by a special LAN signal. Wake-up from the Standby state is
unaffected by this setting and must be enabled in the operating system.
This feature only works when the computer is connected to AC power
supply.
•
Disabled - Does not allow the system to power on by special LAN
signals when it receives a wake-up signal from the LAN or wireless
LAN. (Default Setting)
•
LAN Only - Allows the system to be powered on by special LAN
signals.
•
WLAN Only
•
LAN or WLAN
Allows you to block the computer from entering into the sleep state.
Option is disabled by default.
•
Block Sleep (S3)
Peak Shift can be used to minimize AC consumption during peak powers
times of day. Set the start and end time to run in Peak Shift mode.
•
Enable Peak Shift (Disabled)
Allows batteries in the system in Advanced Battery Charge Mode to
maximize battery health. This uses standard charging algorithm and
other techniques during non-work hours to maximize battery health
•
Enable Advanced Battery Charge Mode (Disabled)
Allows you to define how to use the battery charge, when AC is plugged
in. The options are:
•
Adaptive (Enabled)
•
Standard Charge
•
Express Charge
43