Chevrolet Kodiak 2006 Owner's Manual page 306

First, use these pictures to decide what kind of wheels
you have.
Hub-Piloted Type,
8-Hole
Then, refer to the following steps for the wheels
you have.
5-78
Hub-Piloted Type,
10-Hole
Hub-Piloted Wheels, 8-Hole or 10-Hole
The studs and nuts used with these wheels have
right-hand threads.
1. With intermittent pilot pads, position a pad at
12 o'clock to center the wheel and reduce run-out.
2. Put the tire and rim assembly on the axle hub.
Install the outer rear tire and rim assembly so
that its valve stem is exactly opposite the valve
stem on the inner tire and rim assembly.
3. Put on the wheel nuts.
4. Finger-tighten the nuts.
5. Oil the surfaces (B)
between the nuts (C)
and washers (A). Do
not oil the studs or the
threads of the nut.