Table of Contents
Advertisement
USER MANUAL - BEAM 300 / BEAM 700
-There should be a terminator on the last unit of DMX Chain.
Connection to the Mains
Before use this fixture safely, please install a suitable plug on the power cord, and make sure the
fixture is appropriately earthed.
Please refer to the following table:
CONTROL MODE
DMX address of fixtures ranges from 001-504/488.Please note that the maximum range should not
exceed 504/488.
DMX Addressing
Please set DMX Address of fixture on LCD Display
For example, selecting 16BIT MODE 1, then the DMX Address of the first light is 001 (001-024).
The second one will display 017(015-039), and so on.
Caution
It's necessary to insert the XLR terminator (by connecting a 1/4W 120
between signal PIN-2/ +3)
on the last fixture of a DMX Chain to avoid possible signal interference.
LCD Menu Display Instruction
Function Mode:
ENTER
ESC
Press button
to enter Menu, and press button
back to display setting:
There are corresponding submenus for specific function under the main menu. For details, please
refer to Graph below:
-It is used to set DMX Address of fixtures from 0-511.
-It displays fixture Info.
5
Advertisement
Table of Contents
