Advertisement
Maintenance
1.
Always turn off the power and disconnect the unit when not in use.
2.
Wipe all of the components to remove any moisture after each use.
3.
Make sure the terminal contacts on the Battery (4) are clean and free of
corrosion.
4.
After six hours of use, charge the Battery (4) following the directions below.
5.
Keep the Camera (1) lens clear of dirt or debris.
Never reverse the polarity when connecting the Battery (4) for charging it or
running the system. The Red (+) terminal must be attached to the Red (+) clip on
the Battery , and the Black (-) terminal must be attached to the Black (-)clip.
(See Figure 4, page 2).
Battery Charging
Connect the two clips of the Charger (6) to the corresponding positive and negative
terminals on the Battery (4). Plug the Charger (6) plug into the power outlet. The
indicator on the Charger (6) will stay red until the charger is complete. Once the
charge is complete, the indicator will turn green. Promptly unplug the unit from the
power outlet and remove the clips from the terminals. Do not overcharge the
battery; overcharging can result in damage to or acid leaking from the battery.
Troubleshooting
If the system is not operating properly, by displaying a rolling, shrunk, or unstable
picture, check all of the connections. Next, make sure the Battery (4) is fully
charged. Also, check to make sure the fuse on the Battery (4) is good. If the system
still does not work properly, take the system to an authorized service technician.
Scope of delivery
Part No.
1
2
3
4
5
6
7
Note: Sunshade (7), not shown in Figures.
(Figure 4, page 2)
Description
Camera
Monitor
20m Cable (attached to Camera (1))
Battery
Case
Adapter
Sunshade
PerfectView RV-MARINE/LCD
7
Advertisement
