Advertisement
PerfectView RV-MARINE/LCD
Operation (continued)
Connecting the system (continued) – with reference to Figure 1 (page2)
1.
Set the Monitor (2) in a dry, stable position, out of the direct sunlight and in
accordance with the operational warnings above or simply leave in the case
lid reccess provided. Set the Sunshade on top of the Monitor (2). Just a few
feet from the Camera (1), run the 20m Cable (3) around a railing or post to
keep the weight of the Camera (1) from dislodging the Monitor (2) from its
stable position. Plug the Cable into the Monitor (2).
2.
Set the Battery (4) in a dry position, on a plate or other flat, stable surface
out of the sun, close enough for the Battery to reach the rear of the Monitor
(2). Attach the Black (-) alligator clip on the Battery to the Black (-)terminal
on the Battery (4). Attach the Red (+) alligator clip on the Battery to the Red
(+) terminal on the Battery (4).
Plug the other end of the Battery into the female plug of the power cable .
3.
Turn on the POWER button on the front of the Monitor (2).
See Figure 2 (page 2).
4.
Press MENU button, select to adjust the Monitor.
Note: The Ballast (see Figure 3, page 2) can be set so that the Camera (1)
can be set to have no angle, or angled slightly down ballast or up. Slightly
open the bracket on the Camera (1) to tilt the Ballast.
5.
Gently lower the Camera into the water and reel out the 20m Cable (3) until
it is at the appropriate depth.
6
Adjust the Brightness and Contrast of the Monitor (2)
7.
When you are finished, remove the Camera (1) from the water, turn off the
POWER switch on the Monitor (2), disconnect the alligator clips on the Battery
from the Battery (4) and unplug the Battery from the Monitor (2) and the
camera (1)
8.
The LED can be switched ON/OFF by switch LED ON/OFF BUTTON
9.
The brightness of the Camera can be adjusted by pressing the MENU button to
LED on top of the screen then press the +/- to increase or decrease the
brightness of the LED in the camera.
Warning!! Always keep the Monitor (1) and Battery (4) dry and protected from
the elements. Never try to disassemble the Camera (1) waterproof housing.
6
Advertisement
