Advertisement
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must be
under-stood by the operator that common sense and caution are factors which
cannot be built-in to this product, but must be observed by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 7 are included.
Monitor and Underwater Camera specific safety warnings
1.
Keep the Monitor Fig.1 (2) out of the direct sunlight. Do not let it overheat,
freeze, or be exposed to wet conditions.
2.
Do not locate the Monitor Fig.1 (2) near radiators, ovens, or any other heat
source.
3.
Always handle the Monitor Fig.1 (2) and the Camera Fig.1 (1) with care. Do
not allow either to experience shaking or strong vibration. Never use the
Camera in surf, near a pier, rocks, or any other obstacle.
4.
To allow air circulation, locate the Monitor Fig.1 (2) at least two inches from
walls, cabinets, or other enclosures.
5.
When connecting the Camera Fig.1 (1) to the Monitor Fig.1 (2), the power
must be off or both units will be damaged.
6.
If battery acid leaks on you, immediately wash off the acid with cold water.
Seek medical attention immediately.
7.
Always keep the RED (+) terminal on the Battery Fig.1 (4) disconnected
unless the system is being used. When connected, it will constantly drain the
Battery Fig.1 (4).
Operation
Connecting the system:
Note: This is a 12 Volt DC system and will not work on 24 Volt DC systems;
hooking the monitor up to a 24V system can damage or ruin this product.
Inputs shown in FIGURE1:
DC 12 Volt In- Plug in 12 VDC power system here.
Video Out-can be used to record to a VCR.
PerfectView RV-MARINE/LCD
5
Advertisement
