Table of Contents
Advertisement
outside the jumper area!
To cut this connection, locate pad 7 of area
J
on the component side of the I:x>ard
and
turn the I:x>ard over.
Locate pad
7 on this side of the board and notice that there is a trace which leads
from the pad to the large 5V trace at the left.
This also leads to pad
5 via an indirect route.
To cut the jumper from pad 7 to pad 5 of
jumper area cut this trace.
Schematic errata- on page 5 of the Sdlematic.
Area L pad 6 should
be
labelled pad 7 and pad 7 should
be
labelled pad
6.
Make the same change for area M.
Area
J
is correct as it is.
Advertisement
Table of Contents
