Error Codes - LinMot E1400-GP-QN-xS Installation Manual

7 Error Codes

Error Warn
Off Warning
On ● ~2Hz
0..15 x
Error Code
High Nibble
● ~2Hz ● ~2Hz
0..15 x
Error Code
High Nibble
● ~4Hz ● ~2Hz
0..15 x
Error Code
High Nibble
● ~0.5Hz ● ~0.5Hz
Off
M●●●
The meaning of the error codes can be found in the
Usermanual_MotionCtrl_Software_SG5 and the user manual of the installed
interface software. These documents are provided together with LinMot-Talk
configuration software and can be downloaded from www.linmot.com.
NTI AG / LinMot ®
Error Codes
EN
Operation Normal Operation:
Enabled Warnings and operation enabled are displayed.
● ~2Hz Error:
0..15 x The error code is shown by a blink code with "WARN" and "EN".
Error Code The error byte is divided into low and high nibble (= 4 bit).
Low Nibble "WARN" and "EN" are blinking together.
The error can be acknowledged.
(e.g.: WARN blinks 3x, EN blinks 2x; Error Code = 32h)
● ~2Hz Fatal Error:
0..15 x The error code is shown by a blink code with "WARN" and "EN".
Error Code The error byte is divided into low and high nibble.
Low Nibble "WARN" and "EN" are blinking together.
Fatal errors can only be acknowledged by a reset or power cycle.
(e.g.: WARN blinks 3x, EN blinks 2x; Error Code = 32h)
● ~2Hz System Error:
0..15 x Please reinstall firmware or contact support.
Error Code
Low Nibble
On Signal Supply 24V too low:
The error and warn LEDs blink alternating if the signal supply +24V (X4.2) is
less than 18VDC.
Plug&Play Communication Active
●M●●
This sequence (Warn on, then En on, then both off, complete sequence of the
4 states ca. 1Sec) signalizes the state when the plug and play parameters are
being read from the motor.
www.LinMot.com
E1400 V1 Rev. E Installation Guide
Description
Page 17/23