Cold Start Switch - Mitsubishi Fuso FK/FM 2006 Owner's Manual

5-4
Switches and controls
•
LOCK:
Starter key
when it is in this position. To return the starter
key to the "LOCK" position, first turn the key to
the position midway between the "ACC" and
"LOCK" positions (marked "•"), and after holding
down reset button
back to the "LOCK" position. When the key is
removed, the steering wheel locks.
The light switch, brightness control switch, haz-
ard warning lamps, interior lamp, spot lamp,
Z11728
horn, and central door lock can be used.
•
ACC:
The engine is shut off or is not running in this
position.
The turn signal lamp, wipers, washer, power
windows and cigarette lighter can be used. Any
audio system (such as a radio) that has been
installed in the vehicle and correctly wired can
also be used.
•
ON:
The engine is running in this position.
All electrical circuits are operable.
Z00046
•
S:
The engine is turned over and started in this
position.
Once the engine is running, release the starter
key and the switch will automatically return to
the "ON" position.
NOTE:
•
Insert the starter key fully in the starter switch
before turning it.
•
If you are unable to turn the starter key, gently
turn the steering wheel clockwise and counter-
clockwise as you turn the key.
When starting the engine in freezing temperatures,
or when you want to shorten the warm-up time or
boost interior heating during parking, press this
switch to ON.
When the switch is turned to ON, the exhaust brake
will be applied. This makes the engine warm up
Z11734
quicker after start-up. Indicator lamps
light up.
NOTE:
•
Be sure to press the switch to OFF before start-
ing your vehicle.
•
In cold-temperature environments, white smoke
in the exhaust gas may decrease for several
minutes after pressing the cold start switch ON,
then increase again after a while.
can be inserted and removed only
, turn it the rest of the way

Cold start switch

and