Blade Installation; Valve/Handle Disassembly - Reliable Equipment LR-CS-82 Operator's Manual

BLADE INSTALLATION

WARNING
Blade must be installed to rotate in the correct direction. Follow the blade manufacturer's
instructions and refer to the illustration later in this manual.
Inspect blade for wear or damage before installing and before each use. A damaged
blade may break causing a hazard for the operator, other personnel and/or bystanders.
Failure to heed these warnings could result in severe bodily injury or death.
Inspect all parts for wear or damage before replacing the blade. Replace as needed.
Inspect blade for wear, bending, cracking or damage. (Discard or destroy damage blades.)
1. Install the Blade (1) onto the Locating Washer (13).
2. Slide the Blade Washer (14).
3. Install lower portion of the Split Nut (15) by turning in the
counterclockwise direction.
4. Install the Split Nut (15) onto shaft and lower nut by
turning the upper nut in the counterclockwise direction
while securing the lower nut and shaft in place.

VALVE/HANDLE DISASSEMBLY

Remove the three button head screws (13) holding the trigger guard to the valve
body. Remove one snap ring (15) from the pin (14), holding the trigger to the valve
body, and remove pin. Before removing the control knob (1), mark the relative position
to the spool (5). Remove pin (6) from spool (5). Remove retaining ring (2) and remove
knob (1) from the spool (5). Remove washer (3) and spring (8). If there is a problem
with the O-ring (11), remove the bottom retaining ring (2), the bottom washer and
with an O-ring removal tool, remove O-ring (11) for inspection.
Contact RELIABLE EQUIPMENT at 800-966-3530 if you have any
questions related to the instructional information found in this manual.
These specifications must be strictly adhered to for this tool to function
properly. Any deviation can cause tool damage, severe injury or death.
Use only factory specified parts when repairing and/or replacing.
Severe tool damage or personal injury may occur with non-specified parts.
Always use appropriate blades meeting applicable industrial safety
specifications for the use intended by the manufacturer.
(Refer to Figure 4, Page 16)
(Refer to Figure 3, Page 15)
18