Table of Contents
Advertisement
MAINTENANCE
The service schedule should be followed
as closely as possible. The life, reliability,
and safety of the tool is dependent on
maintenance and will help the tool to remain
productive for a much longer period.
DAILY MAINTENANCE
CLEAN: All surfaces including handle,
trigger, trigger safety latch, fittings, hoses,
motor housing, and especially the fiber-
glass extension tube.
INSPECT: Saw head, blade, handle and
trigger assembly for wear and damage.
Wo r n or damaged parts can cause a
malfunctionduring operation. An improperly
sharpened blade can cause kickback.
NOTE: A cracked, bent, or damaged blade
should be destroyed. A damaged blade
may break causing a hazard for the operator,
other personnel and/or bystanders.
Visually inspect saw frequently while in
use (NOT RUNNING). Inspect for tool or
blade damage. Inspect for cracked hoses
and leaking fittings.
All the above items must be replaced with
new parts if signs of wear are evident.
CHECK: Fluid level of power source frequently.
FLUID CONTAMINATION: Cover the ends of
fittings with a rubber dust cap when
disconnected. This will help keep the fluid
from contamination.
MONTHLY MAINTENANCE: Inspect per
Appendix A, SAE Standard J1273, 5/86 for
hose or fitting damage such as wear, cracks
or leakage, replace the necessary parts.
NOTE: Keep Label Set clean and legible.
Replace labels as needed. Part # RL44000
Contact RELIABLE EQUIPMENT, or your
RELIABLE representative if you have any
questions related to the information found
in this manual.
NOTICE
Read and understand Manual
and ALL SAFETY WARNINGS
before operation of this tool.
Failure to observe warnings may
result in property damage and/or
serious personal injury
DANGER
To avoid severe personal injury,
inspect tool before each use.
DO NOT operate with loose,
missing or damaged fasteners.
CAUTION
DO NOT EXCEED
specified flow or pressure
2,000 PSI / 140 BAR
5-7 GPM / 19-26 LPM
Select Closed Center for use
with Closed Center System.
Select Open Center for use
with Open Center System.
See Manual for Instructions
DANGER
The saw blade will continue to
rotate for up to 5 seconds or
more after releasing trigger.
During this coast down time,
any contact with the blade may
result in property damage,
and/or severe personal injury.
After releasing trigger, DO NOT
place saw on the ground, lower
saw into bucket, store saw, or
make contact with personnel,
bucket, boom or vehicle.
Keep personnel, and bystanders
clear of blade, falling limbs,
branches and debris.
USE EXTREME CAUTION
Contact at leak or burst may
cause an oil injection injury.
WARNING
ELECTRICAL SHOCK HAZARD
Use extreme caution when
operating
near
energized cables.
12
or
around
Advertisement
Table of Contents
