Pre-Operation; Spool Selector (Fig. 1) - Reliable Equipment LR-CS-82 Operator's Manual

PRE-OPERA PRE-OPERA
PRE-OPERA PRE-OPERA TION OF SA PRE-OPERA
DO NOT connect hoses or fittings to this unit before completing
all of the instructions in this section.
Ensure power source is OFF, and hydraulic flow is lever is turned OFF.
WARNING
Failure to comply with this warning can result in severe injury or death.
Before attempting to connect, run, or use the saw, inspect all parts an sub-assemblies,
including hoses, couplings, blade assembly, cleanliness of the fiberglass extension,
trigger latch, freely moving trigger, and the condition of the rubber behind the trigger.
Worn or damaged parts can cause a malfunction during operation and should be replaced.
Inspect the saw blade for damage. The saw will not function properly with a worn (Dull)
or damaged blade. Look for bending, cracking, wear, or any damage to the blade assembly.
A worn or damaged blade could allow pinching, cause kickback, or break creating flying
debris that could result in serious injury to the operator, nearby personnel or bystanders.
Set saw to Open or Closed Center, according to which system the power supply pump provides
It is important to know which type of power system is supplying the saw so that the
saw can be properly set.
FIGURE 1
Setting Spool Selector for Open Center/Closed Center System
Set the Hand Stop approximately 36" from the handle. This should be a comfortable
position for the average person.
Wear all safety items required and make sure that the working area is clear of obstructions.
Ensure all personnel and bystanders are well outside the danger zone.
All of these items are crucial to the safe operating procedure of the saw.
Ensure power source is OFF, and hydraulic flow is lever is turned OFF.
Connect Saw as described on page 9.
Turn ON hydraulic source and flow control lever. (refer to specifications on page 8)
Allow the power source to run for a few minutes to warm the hydraulic fluid.
Operate newly mounted blades on saw for approximately one minute to ensure proper
blade application before cutting material.
TION OF SA TION OF SA W W W W W TION OF SA
TION OF SA
10