Operation; Bluetooth Connection; Connection Priority; Making A Call - Subaru Impreza SEDEFG6000 User Manual

When you enter the vehicle and turn on the ignition, the system will automatically establish a
Bluetooth connection with your phone.
If it is the first time the connection has been made or your phone was not the last phone
connected, it will take between 40-90 seconds to connect - otherwise it will take around 10
seconds.
Some phones are faster than others at establishing Bluetooth connections so the system leaves
time for the phone with the highest priority to connect first before searching for the next phone.
Connection is confirmed by the phone or the system giving 3 ascending beeps (dependent upon
phone).
The system will prioritise which phone it connects to first:
Priority 1
Priority 2
Therefore: If there are 3 phones paired to the system and you enter the vehicle at the same
time, the person who last used the system will be connected first. Should that phone not be
found, the next phone to be connected would be the one who has used the system most in the
past.
Should you want to choose which phone connects to the system, it will be necessary to turn off
the Bluetooth function of the phone/s you do not want to connect then turn on the vehicle ignition
again.
1) Voice Dialling:
Press the control button once quickly to activate the voice dialling feature. The system will
give an audible beep to confirm it is ready to receive the voice command. Speak the name of
the contact you wish to call.
NOTES:
The system will only recognise the contacts voice tags which are prerecorded on the phone.
See your phones user guide on how to record voice tags.
It is also recommended to record the voice tags on to the phone through the handsfree
system as this will be more representative of the voice command used when in the vehicle.
If the phone has no prerecorded voice tags it will acknowledge with 4 audible beeps.
To cancel the voice dialling simply press the control button again.
2) Dialling a number:
Enter the required phone number on the phone itself and press the dial button.
3) Redialling a number:
To redial the last called number, press and hold the button until you here a single audible
beep - after approximately 2 seconds. The system will give a series of ascending beeps then
re-call the last number dialled.
To hang up a call or reject an unwanted call, simply press and hold the control button until you
here a single confirmation beep - after approximately 2 seconds.

Bluetooth Connection

Connection Priority

The last connected phone
The phone connected most times

Making a call

Rejecting a call

- 5 -

Operation