Dressing The Cutting Block; Replacement For Needle Thread Trimmer - Suzuki SE200-M SERIES Operation Manual

5. DRESSING THE CUTTING BLOCK

CAUTION: Switch off the main switch before doing it.
When replacing a cutting block, a surface of block must dress very
carefully by oilstone or paper file (#0) for perfect cutting after
adjusting the cutting block pressure even if it is a new block. The
figure (B) is a badly dressed block and (A) is perfect one.
condition for the block is that a shape of knife is marked a little bit on
the cutting block.

6. REPLACEMENT FOR NEEDLE THREAD TRIMMER

CAUTION: Switch off the main switch.
Replacement position is that the machine should be the start position.
a) Loosen the screw (A), remove the thread trimmer and replace a new one (part No. S1-3881). The
position of it is as shown in figure ②. Tighten the screw (A) after replacing.
position of thread trimmer and thread trimmer fixing arm whether it does not hit to other parts by
moving the thread trimmer fixing arm to left with your hand before starting the machine.
b) If the thread trimmer or thread trimmer fixing arm hits to the some parts such as spreader, spreader
stopper or needle plate, loosen the screw (B) and adjust the height of thread trimmer fixing arm up or
down. After adjusting it, tighten the screw (B) as shown in figure ①.
(A)
Figure ①
(B)
Good
(A)
26
(A) (B)
Please check the
Figure ②