Control Valve Programming And Regeneration; Installer Display Settings; Power Lost; Error Message - 3M 3MWTS100 Installation And Operating Instructions Manual

SECTION 3: CONTROL VALVE PROGRAMMING AND REGENERATION
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
RETURN TO
NORMAL MODE

Installer Display Settings

(Step 1) Press SET CLOCK. Push
minutes. Press NEXT to lock time in.
(Step 2) Press NEXT and
(Step 3) Hardness: Set the amount of hardness in grains of hardness as calcium carbonate per gallon
using the or buttons. The default is 20 with value ranging from 1 to 150 in 1 grain increments.
Note: The grains per gallon can be increased if soluble iron needs to be reduced. Press NEXT to go
to Step 3. Press REGEN to exit Installer Display Settings.
(Step 4) Day Override: Day Override sets the number of days between regenerations and sets the
maximum number of days between regenerations. If value is set as a number (allowable range from
1 to 28) a regeneration initiation will be called for on that day even if suffi cient number of gallons
were not used to call for a regeneration. Set Day Override using
• number of days between regeneration (1 to 28); or "OFF".
Press NEXT to go to Step 4. Press REGEN to return to previous step.
(Step 5) Next Regeneration Time (hour): Set the hour of day for regeneration using
AM/PM toggles after 12. The default time is 2:00 a.m. Press NEXT to go to Step 5. Press REGEN to
return to previous step.
(Step 6) Next Regeneration Time (minutes): Set the minutes of day for regeneration using
buttons. Press NEXT to exit Installer Display Settings. Press REGEN to return to previous step.
To initiate a manual regeneration immediately, press and hold the "REGEN" button for three seconds.
The system will begin to regeneration immediately. The control valve may be stepped through the
various regeneration cycles by pressing the "REGEN" button.

Power Lost

If a outage of eight hours or more occurs, the time of day will fl ash on and off which indicated the
time of day should be reset. The system will remember the rest.

Error Message

If the word "error" and a number are alternately fl ashing on the display contact our Customer Care
Team at
855-3M-WATER (855-369-2837)
properly.
or to change hour (AM/PM). Press NEXT then
simultaneously for 3 seconds.
for help. This indicates that the valve was not able to function
3-1
or to change
or buttons.
or buttons.
or