Wideye Skipper 150 User Manual page 119

Symptoms Descriptions / Remedial Actions
Signal Strength • Check any obstruction such as the hull or monkey bridge of the
is low or too
low ( less than • Check any interference signal from the antennas that are closed to
45dBHz )
• Depending on the antenna's location on the vessel, the vessel's
Symptoms Descriptions / Remedial Actions
Antenna keeps • Check that the sky/satellite view of ADU is not blocked.
searching • Wait a little bit longer. A FB terminal has to scan through the three
for satellite
continously
• Check that the FB terminal is NOT configured to lock to a particular
Symptoms Descriptions / Remedial Actions
Antenna does • Check the BDU is powered up by looking the LEDs, which are green.
not move or • Check the output voltage at the antenna connector at the BDU is
rotate
Symptoms Descriptions / Remedial Actions
No light appear • Check to ensure that the input DC power will have at least +24V DC,
on Terminal LED
• Check to ensure the circuit breaker at the panel is fully depressed at
vessel that may block the ADU's line of sight.
the antenna.
route may cause the ADU's line of sight to be blocked any structure
of the vessel, depending on the elevation of the satellite.
I-4 satellites (Americans, EMEA and Asia- Pacific) one by one to
look for BGAN signal to operate on. Depend on location of vessel,
this process can take as long as 6 minutes.
I-4 satellite (Manual Satellite Selection) that can't be seen (by ADU)
at current location.
+43V.
10A or +12V DC, 20A.
"ON" position.
117