Operating Manual Reprint; Front Panel; Rear Panel - Vertex Standard VXR-1000 (UHF) Service Manual

Operating Manual Reprint

Front Panel

Microphone Jack
Connect the microphone plug to this jack.
CHANNEL Selector Knob
This knob selects the operating channel.
PRI Indicator
When on, "PRI" indicates that the unit is at
priority count zero and will repeat all trans-
missions.
TX Indicator
When on, "TX" indicates that the repeater is
transmitting to the handheld.
COR Indicator
This lamp blinks red when the VXR-1000 is
receiving a signal from a handheld, and glows
red while the VXR-1000 is receiving a sub-
audible tone from the handheld.
MBL Indicator
This lamp blinks red when the Mobile is re-
ceiving signal from repeater or base, and
glows red while the Mobile is transmitting
to the repeater or base.
PWR Indicator
This is the main "P
VXR-1000.
VOLUME Knob
This knob adjusts the receiver volume.
Error Message
No Channel Data
(Operating Channel is Vacant)
ARTS Out of Range
2
C
ONTROLS
O " indicator for the
OWER N
, , and Indicators
Blink
PWR Indicator Blinks
& C
ONNECTORS

Rear Panel

EXT SP (External Speaker)
An external loudspeaker may be connected
to this 2-contact, 3.5-mm mini-phone jack.
DSUB 9-Pin Accessory Connector
External TX audio line-input, PTT, external
RX audio line-output, and other signals may
be obtained from this connector for use with
accessories.
Pin Assignments
Pin 2 Mobile Transmit Audio Pin 3 Power Supply Control
Pin 4 Mobile PTT Output
Pin 6 Mobile Receive Audio
Mobile Microphone
Pin 8
Audio
Antenna Socket
The Antenna socket is a standard 50 Ω BNC
antenna connector.
Pin 1 GND
Pin 5 Vcc (13.8V DC)
Pin 7 Mobile COR Detect
Mobile TX
Pin 9 Detect/Mobile
Microphone PTT