Protek Samurai 321B Instruction Manual page 8

N O T E S W H E N A P P LY I N G
T H E S TA R T E R B O X
DO NOT over prime the engine. This could cause a hydraulic lock and damage the engine
when the starter is applied.
• If over-primed, remove the glow plug, close the high speed needle valve, cover the head
with a rag and apply the starter to pump out excess fuel. The rag will help to prevent fuel
from coming into contact with your eyes.
DC
ston
ngine is hot.
O-Ring
05
No. Part Description
Number
1 PTK-2501 Cooling Head
2 PTK-2508 Turbo Plug Button Head
3 PTK-2509 0.1mm & 0.2mm Head Gasket/Shim Set
4 PTK-2507 Complete Piston/Sleeve/Rod Assembly
5 PTK-2503 Complete Carburetor
6 PTK-2514 Carburetor Retainer Assembly
7 PTK-2504 7x19x6mm Front Engine Bearing
8 PTK-2502 Crankcase
9 PTK-2505 14x25.4x6mm Ceramic Rear Bearing
10 PTK-2506 Crankshaft
11 PTK-2512 Rear Cover Plate O-Ring
12 PTK-2511 Rear Cover Plate
13 PTK-2542 P3 Turbo Glow Plug (Ultra Hot)
* Specifications are subject to change without notice.
* See additional option parts on Pg.33
Carburetor Restrictor (Venturi)
High Speed
Needle
(Needle Valve)
Mid Needle
(Mixture Control Valve)
Slide Boot
Idle Screw
(Throttle Stop Screw)
Ball Link
30