Protek Samurai 321B Instruction Manual page 6

N O T E S
• Before starting the engine, verify that all fasteners, especially those at joints and
moving parts (such as the throttle arm) are tight and secure. Loose fasteners are
often the source of catastrophic problems and could lead to injury or property
damage.
• To stop the engine during normal operation, reduce the throttle to neutral, flip the
car over and push a blunt rubber object against the flywheel.
• To stop the engine in the event of an emergency, use a blunt rubber object to
plug the exhaust and flood the engine (recommended), or cut off the fuel supply by
pinching the fuel delivery line from the fuel tank. In the event of an emergency DO
NOT attempt to stop the engine at the flywheel.
• WARNING! Immediately after a glow type engine has been shut off, while the
engine is still warm, conditions exist that make it possible for the engine to abruptly
re-start if the piston is rotated through the compression point (top dead center:
TDC), WITHOUT the glow plug igniter being connected.
03
No. Part Number Description
1 PTK-2529 Ball Link
1-1 PTK-H-4000 3x3mm Set Screw
2 PTK-2535 Carburetor Boot
3 PTK-2530 Low Speed Needle
3-1 PTK-2531 Low Speed Needle O-Ring
4 PTK-2503 Slide Valve (Carburetor Complete)
5 PTK-2524 Carburetor Restrictor – 7mm "Elliptical"
5 PTK-2526 Carburetor Restrictor – 8mm "Elliptical"
5-1 PTK-2517 Carburetor Restrictor O-Ring
6 PTK-2540 High Speed Needle
6-1 PTK-2541 High Speed Needle O-Ring
7 PTK-2537 High Speed Needle Housing
7-1 PTK-2538 Fuel Inlet with Gasket
8 PTK-2543 Idle Screw
8-1 PTK-2536 Idle Screw O-Ring
9 PTK-2532 Mid Rangle Needle
9-1 PTK-2533 Mid Range Needle O-Ring Large (2)
9-2 PTK-2534 Mid Range Needle O-Ring Small (2)
10 PTK-2513 Carburetor Outer O-Ring
* Specifications are subject to change without notice.
32