Emergency Stopping; Notes On Operation - Princess auto EHS350A Operation And Parts Manual

4. Emergency stopping (Ref. Fig.8)
Under normal conditions, the machine is to be turned off
when the engine idles. However, if a malfunction or
emergency occurs during cutting, you can stop the engine
immediately by pressing and holding the kill switch (2) on
the front end of the rear handle (1). But note that the service
life of some components of the saw may be adversely
affected if the engine is stopped too often during cutting.

5. Notes on operation

. Follow all applicable instructions in this manual when operating the cut-off saw.
. During the break-in phase, which takes about 8 hours, the saw must not be operated
at high speeds without load (better do not pull the throttle trigger beyond 3/4 of full
throttle.). Following this procedure will lengthen the service life of your machine.
31
Fig. 8