Table of Contents
Advertisement
Configure NAT maps
Introduction
General remarks
40
6.3 Configure NAT maps
This section explains the configuration of the different NAT maps.
6.3.1 Basic NAT
6.3.2 Two-Way NAT
6.3.3 N-N NAT
6.3.4 Multi NAT
6.3.5 Transparent NAT
Depending on the NAT flavour some configuration information is mandatory other
not.
In this chapter we put the mandatory information in
The following information is always mandatory:
Interface
Outside address
Not mandatory information is:
Protocol
When selecting a protocol, then the map will only have affect for that protocol.
Access list
You can use the access list to define the address (es) that are allowed to use
the outbound connections.
Foreign address
Foreign address is to define the address (es) that are allowed to use the inbound
connections.
If you leave protocol, access list or foreign address empty. This means that
every protocol (for protocol field) or every IP address (es) (access list,
foreign address) is valid.
W
Topic
emphasis.
Page
41
42
43
44
46
E-NIT-CTC-20040716-0004 v1.0
Advertisement
Table of Contents
