Create An Address Translation Mapping - THOMSON SpeedTouch Configuration Manual

6.1.3 Create an address translation mapping

Introduction
Create a NAT map
E-NIT-CTC-20040716-0004 v1.0
An address translation map is used for mapping one or more private IP addresses into
one or more public IP address on a specific interface.
Proceed as follows:
Select the Mappings menu and click New to create a new map
1
Select NAT from the Type list.
2
Select or fill in all required information:
3
Portmap
properties
Interface
Protocol
Outside address
Create an address translation mapping
Description
The name of the IP interface that needs to be address
translated.
Note: The interface must previously have been NAT
enabled, see "6.1.2 Enable/disable address translation
on an interface" on page 30.
Any interface means all interfaces.
The IP protocol on which address translation has to be
applied.
Advantage: To link specific traffic (protocol dependent)
to a chosen private host. Any protocol means all
protocols.
The outside (typically public) IP address(es).
31