Sony MEX-N5100BE Service Manual page 18

MEX-N5100BE/N5100BT/N5150BT
Installing the microphone
To capture your voice during handsfree calling, you
need to install the microphone .
Clip (not supplied)
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before
installation.
Note
Before attaching the double-sided tape
surface of the dashboard with a dry cloth.
Using the wired remote control
1
To enable the wired remote control, set
[STR CONTROL] in [SET STEERING] to
[EXTERNAL] (page 17).
.
18
Installation
Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar and the bracket
1
Pinch both edges of the protection collar
, then pull it out.
2
Insert both release keys
click, and pull down the bracket
pull up the unit to separate.
Face the hook inwards.
, clean the
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket
in).
1
Position the bracket
dashboard, then bend the claws outward
for a tight fit.
from the unit.
2
Mount the unit onto the bracket
until they
attach the protection collar
, then
Notes
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
are bent inwards 2 mm ( 3 /
32
inside the
182 mm (7 1 / in)
4
53 mm (2 / in)
1
8
Catch
, then
.
Fuse (10 A)