Sony MEX-N5100BE Service Manual page 16

MEX-N5100BE/N5100BT/N5150BT
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[SET STEERING] [STR EDIT] to make the
registration (page 19).
.
When the registration completes, the steering wheel
remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
Do not connect this cable when the steering wheel
remote control is not used.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [EXTERNAL]
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
TOYOTA
to dashboard/center console
Bracket
Existing parts supplied with
your car
NISSAN
to dashboard/center console
Bracket
Existing parts supplied with
your car
Note
To prevent malfunction, install only with the supplied
screws .
16
Installation
Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar and the bracket
1
Pinch both edges of the protection collar
, then pull it out.
2
Insert both release keys
click, and pull down the bracket
pull up the unit to separate.
.
Face the hook inwards.
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Bracket
Bracket
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket
in). When mounting in a Japanese car, see
"Mounting the unit in a Japanese car" (page 37).
1
Position the bracket
dashboard, then bend the claws outward
from the unit.
for a tight fit.
2
until they
Mount the unit onto the bracket
, then
attach the protection collar
Notes
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Fuse (10 A)
are bent inwards 2 mm ( /
3
32
.
inside the
182 mm (7 1 / in)
4
53 mm (2 1 / in)
8
Catch
, then
.