Table of Contents
Advertisement
3
P
C
P
C
.
If you don't use the uConfig Utility you need to establish Ethernet connection between your PC and the
AIRNET Indoor High Power Access Point, by default the indoor AP has the IP address 192.168.168.1.
Therefore, your PC must be in the same network segment as the AIRNET Indoor High Power Access Point is to
get Ethernet connectivity.
Step 1
Go to Start button, then go to My Network
Places and finally click on Network
Connections.
Right-Click over your network adapter and
select Properties.
Step 2
Select the Internet Protocol Option and then
click in Properties.
Step 3
Now configure the IP Address of your
network adapter with an IP in the same
Network segment as your AIRNET Indoor
High Power Access Point is as it is shown in
the picture, you don't need to assign any
gateway address.
Press OK and then press the Close button.
C
o
n
f
i
g
C
o
n
f
i
g
u
r
a
t
i
o
n
u
r
a
t
i
o
n
Advertisement
Table of Contents
Need help?
Do you have a question about the Access Point and is the answer not in the manual?