Netkrom Access Point Quick Installation Manual page 12

Follow these steps to setup Transparent
Client/s.
Step 1
Select the Remote AP MAC
Enter the Remote AP
address of your Remote AP under About
system >> Wireless MAC.
Ensure that The Current Mode
Transparent Client.
Step 2
Select the Remote AP MAC
Enter the Remote AP
address of your Remote AP under About
system >> Wireless MAC
Note:
When using Remote AP
name must also match the AP's ESSID name,
especially when Closed System is enabled on
the AP.
Repeat the Transparent Client steps to add
more Clients to the Point-to-MultiPoint
connection.
checkbox.
MAC. Check the MAC
is set to
checkbox.
MAC. Check the MAC
MAC, the ESSID