da Vinci 1.0 User Manual
Open the box
Open the box and
1
remove the accessories
and the cushion.
Remove the cardboard.
5
Remove the drip tray packaging
8
tapes.
Note: Cable tie illustrated in step 4 in this section is used to fix the extruder during transportation.
It should be removed before powering on the printer, or the printer may not funtion normally.
Take out the printer
2
by holding the side
handles.
Remove the print bed shipping tapes and
6
foam cushioning pieces.
Use the USB cable to connect the
9
printer to PC. Connect the power
cord to the printer then turn on the
power switch.
Remove plastic
3
4
bag and tapes.
7
A
A
B
B
P 6
Tapex2
Packing support x2
Open the top cover, then remove
packaging supports and tapes from
inside.
Remove the bottom screw and the
plastic piece under print bed.
Cable tie x1