General usage description
®
The Mastercraft
portable and gasless MIG/Flux-Core Wire Feed Welder Kit uses AC single phase
120V, 60 Hz/20A with a time delayed fuse or circuit breaker. The kit provides two heat settings,
infinite wire speed control, overload and thermal protection. The welder kit can be used for welding
mild steel 20 gauge to 1/8" using flux core wire only in light industrial applications.
Guidelines for proper usage and description
REMOVING FROM CARTON
1. Remove cartons, bags, or styrofoam containing the welder and accessories.
2. Check the contents with the packaging list below.
After unpacking the welder unit, inspect for any damage that may have occurred during transit.
Check for loose, missing, or damaged parts. A shipping damage claim must be filled with carrier.
ITEM
Portable MIG welder
Contact tip, 0.023" 0.030" 0.035"
Sample spool flux core wire, 0.030"
Sample spool solid wire, 0.023"
Welding mask
Chipping hammer/wire brush
Instruction manual
Handle
ON/OFF switch
This switch is used to turn the power supply of the welder kit ON and OFF through the main
transformer and control circuit.
MIN/MAX 1/2 voltage setting
Two adjustment switches are provided on the front panel of the welder kit, for setting the minimum
and maximum values of votage and tension. Refer to the set up chart for initial adjustment of the
voltage setting.
MIG/FLUX-CORE WIRE FEED WELDER KIT 058-8195-2
QTY.
1 unit
1 pc
1 LBS
1/2 LBS
1 pc
1 pc
1 manual
1 pc
10