Gain Control; White Balance Control - Samsung SDN-520N Instruction Manual

S S M M
E E T T U U P P E E N N U U

Gain Control

1. Press the SET button to display the setup menu and move the arrow
indicator to 'Gain' using the UP or DOWN button.
2. Select 'AGC' or 'OFF' using the LEFT or RIGHT button.
AGC : Activates automatic gain control feature.
OFF : Deactivates automatic gain control feature.
Camera ID
Backlight
Motion Detect.
Lens
Shutter
Gain
White Balance
If you choose 'AGC', you can adjust the brightness using the LEFT or
NOTE
RIGHT button from 0 to 99.
In 'AGC' mode, you can select the Gain limit 'Low' or 'High' or 'Middle'.
If you choose 'High' in the- 'Gain limit' menu, the image is more
detailed and more noise.
If you choose 'Low' in the 'Gain limit' menu, the image is less detailed
and less noise.
34
COLOR CCD CAMERA
Setup
OFF
OFF
OFF
DC
ESC
AGC
ATW

White Balance Control

Your camera provides 3 white balance control modes. You
can select the most suitable one. You can adjust the white
balance.
1. Press the SET button to display the setup menu and move the arrow
indicator to 'White Balance' using the UP or DOWN button.
2. Select the desired control mode using the LEFT or RIGHT button.
Camera ID
Backlight
Motion Detect.
Lens
Shutter
Gain
White Balance
The three white balance control modes are as follows :
• ATW (Auto Tracing white balance ) : The camera
automatically controls the white balance in any environment.
Do not use 'ATW' mode when the camera is installed under severe
NOTE
lighting condition.
• AWC (Auto White balance Control) : The white balance is
automatically adjusted in a specific environment. In order to
obtain the best result, press the SET button while the camera
focuses on white paper. If the environment including the light
source is changed, you have to adjust the white balance again.
• Manual : To fine adjust, select the Manual mode. You can
increase or decrease the red or blue factor while monitoring the
difference on the screen. To use the mode more effectively, set it
to ATW or AWC mode to obtain a proper white balance, then set
to 'Manual' mode and press the SET button. Increase or decrease
the value for red and blue, watching the color of the picture, and
press the SET button when you obtain the best color.
S S M M
E E T T U U P P
Setup
OFF
OFF
OFF
DC
ESC
AGC
ATW
COLOR CCD CAMERA
E E N N U U
35