Installing The Chute Control Rod - Toro 722 Power Throw Operator's Manual

5
Installing the Chute Control
Rod
Parts needed for this procedure:
Chute control rod assembly (rod and bracket, worm
1
gear, and bracket)
1 Belleville washer
2 Bolt
1 Carriage bolt
3 Locknut
1 Curved washer
Procedure
1. Secure the upper chute control bracket (attached to
the chute control rod) to the upper left side of the
handle with a bolt and a locknut Figure 10.
1. Chute control rod
2. Worm gear, bracket, and
mounting flange
3. Lower chute control
bracket
Note: Leave the locknut loose.
2. Secure the lower chute control bracket (attached to
the chute control rod) to the lower left side of the
handle with a bolt, a curved washer, a flatwasher,
and a locknut (Figure 10).
Note: The bracket should be fastened on the
outside of the handle, and the rod should be
approximately parallel to the ground and not touch
the handle.
Note: Leave the locknut loose.
3. Apply No. 2 general purpose grease to the worm
gear (Figure 11).
11
Figure 10
4. Upper chute control
bracket
5. Curved washer