Product Overview; Checking The Tire Pressure; Checking The Skids And Scraper - Toro 722 Power Throw Operator's Manual

result. Drain the excess oil until the oil level on
the dipstick reads Full.
9. Insert the dipstick into the filler neck and rotate the
cap clockwise until it is tight.
7

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated at the factory for shipping.
Reduce the pressure equally in both tires to between 12
and 15 psi (82 and 103 kPa).
8
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to Checking and Adjusting the Skids and Scraper
in Maintenance.

Product Overview

1. Auger/impeller drive
control lever
2. Traction control lever
3. Discharge chute control
4. Speed selector lever
5. Fuel tank cap
1. Choke
2. Ignition switch
3. Fuel shutoff valve
4. Throttle
13
Figure 14
6. Oil fill/dipstick
7. Chute deflector handle
8. Snow clean-out tool
9. Auger
Figure 15
5. Recoil starter
6. Oil drain plug
7. Primer