Reliable Equipment REL-CS16 Operator's Manual page 4

DO NOT attempt to make any changes to any of the component
parts or accessories when connected to the power source.
WARNING
DO NOT adjust, inspect, or clean tool while the tool is connected
to the power source. The tool could accidentally start up
and cause serious injury.
DO NOT lock the trigger in the On Position. In an emergency, it is impossible
to shut down the tool. Serious damage or injury could occur during the
time required to stop the tool.
DO NOT alter or remove the safety latch attached to the trigger. This latch is
designed to prevent accidental movement of the trigger, which could cause
the chain to start up and cause severe personal injury or property damage.
DO wear protective gloves when handling or adjusting the saw chain. The saw can
and will cause damage to the hands without gloves either running or stopped.
Failure to follow these warnings can result in serious injury and/or death.
Jamming or pinching will occur when the wood being cut
closes in on the top of the chain or guide. This action results
in pushback or a kickback, usually very fast with strong force
WARNING
toward the operator. Be careful and be aware of what causes
this set of circumstances, so the operator can do everything
possible to avoid them.
WARNING
Accidentally touching an object with the tip of the chainsaw
can cause a rapid movement of the assembly up and back
towards the operator, with possible injury to the operator
or damage to the surrounding objects.
WARNING
DO NOT operate this tool with a worn or damaged saw chain.
Wo r n , d a m a g e d , o r d u l l s a w c h a i n w i l l i n c r e a s e t h e
likelihood of kickback or pushback.
Safety
Jamming / Pull-In
Tip Contact / Kickback
Worn or Damaged Saw Chain
4