Table of Contents
Advertisement
READ BEFORE DISASSEMBLY
WARNING
Complete disassembly is not recommended. Return the unit to an authorized dealer for total
disassembly and/or repair.
All maintenance or disassembly should take place on a flat, clean work surface
covered with towels or wipers so as to have a clean space for the disassembled parts.
Inspect each part during disassembly for wear, scratches, and cuts. Discard the worn
or damaged parts and replace with new parts.
O-rings are sensitive to sharp edges. Inspect closely for cuts or damage. A small cut
will cause a leak. When assembling or disassembling O-rings, use hydraulic fluid as
a lubricant to help disassembly or installation.
Before any disassembly, disconnect hoses from the Chainsaw!
Any residual pressure within the unit can and will spray at high
velocity, injuring the person doing the disassembly. Hot or
pressurized hydraulic fluid will cause serious injury to the body!
Accidental movement of the chain can cause serious injury,
dismemberment of a hand, finger or any other part of the body.
22
Advertisement
Table of Contents
