Solenoid Valve System - Yamaha TZ250M1 Owner's Service Manual

EC650001

SOLENOID VALVE SYSTEM

EC651020
INSPECTION STEPS
If the solenoid valve will not operate, use the following inspection steps.
*1 Check fuse.
OK
*2 Check battery
OK
Check each coupler and
wire connection.
OK
*1 Check main switch.
OK
Check solenoid valve
operation.
*1 marked : Refer to "IGNITION SYSTEM" section.
*2 marked : Refer to "BATTERY INSPECTION" section in the CHAPTER 3.
NOTE:
• Remove the following parts before inspection.
1) Cowling
2) Fuel tank
A
3) Induction cap (left cylinder)
• Use l2V battery in this inspection.
• Use the following special tools in this inspection.
Pocket tester:
YU-03112/90890-03112
SOLENOID VALVE SYSTEM
No good
No good
No good
No good
No good
Check solenoid valve coil.
Replace CDI unit.
4) Induction guide (right cylinder)
5) Seat
6-12
ELEC
Replace fuse and
check wireharness.
Recharge or replace.
Repair or replace.
No good
OK
Replace.
Replace.