Advertisement
1. Removing the side panels
1. Unlock the system keylock on the top cover.
2. Draw out the mounting bracket on the top right from the chassis.
2
1
2. Remove the side panels.
2. Removing the top cover
3. Slide the top cover toward the front of the system and li it up.
1. Remove the screws that secure the top right bracket ear to the
4. Disconnect the 4-pin top fan connector.
top cover.
7. Installing the CPU
4
A
B
C
8.Installing the CPU Cooler
1
2
3
3. Removing the VGA Card Holder
1
1. Remove the VGA card holder.
4. Removing the Riser Card
1
1
2. Remove the riser card retention bracket.
5. Installing the Hard Drive-1
1
1. Remove the drive tray assembly.
9.Installing the SO-DIMM
1
2
3
10. Replacing the Riser Card
2
1. Replacing the riser card.
1
6. Installing the Hard Drive-2
1
1
2. Take the assembly apart.
1
1. Remove the PSU.
1
3. Install a 3.5" HDD to the bo om tray.
en secure it to the chassis
and connect the power and SATA data cables.
o r
3
4
2
1
2. Remove the ODD+2.5" HDD Tray.
3. Install up to four 2.5" HDDs.
en secure it to the chassis and
connect the power and SATA data cables.
2. Engage the VGA card holder with the two vertical sliding tracks
while sliding it back to the chassis.
2. Make sure the riser card is well installed.
11. Installing the Graphics Card
VGA card holder
1. Installing the graphics card.
3. Make sure the VGA card holder is well installed and the
graphics card is seated correctly.
1
1
2
3. Install a 2.5" HDD to the HDD tray.
en secure it to the chassis
and connect the power and SATA data cables.
2
3
1. Re-install the PSU.
12. Completing the Installation
2. Replace the side panels and top cover.
Lock the keylock before powering on the system.
Note
Standard-height card:
110-120mm
Over-height card:
VGA support
130-140mm
*If the graphics card you are using is over-height, use the VGA support
to secure the card.
Advertisement
