Taillamp, Tail/Stop Lamp; Rear Turn Signal Lamp; Backup Lamps - Dodge 2013 SRT Viper Owner's Manual

294 MAINTAINING YOUR VEHICLE
NOTE:
• If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
2. Rotate the bulb's socket counterclockwise, and remove
the bulb and socket assembly from the housing.
3. Pull the bulb out of the socket and insert the replace-
ment bulb.
4. Install the bulb and socket assembly into the housing,
and rotate the socket clockwise to lock it in place.
5. Reinstall the front/rear side marker.

Taillamp, Tail/Stop Lamp

For bulb replacement, see your authorized dealer.

Rear Turn Signal Lamp

For bulb replacement, see your authorized dealer.

Backup Lamps

1. Reach behind the rear bumper and press the release
tabs on the backup lamp housing.
2. Separate the backup lamp housing from the rear
bumper fascia.
3. Disconnect the electrical harness connector.
4. Turn the bulb and socket assembly counterclockwise,
and then pull it out of the backup lamp assembly.
5. Remove the bulb from the connector socket and install
the replacement bulb.
6. Reinstall the bulb and socket assembly into the backup
lamp assembly, and then turn it clockwise.
7. Reinstall the backup lamp housing into the rear bum-
per fascia.