Kenwood TK-3302 Service Manual page 30

TK-3302/3302
Item Condition
6. QT Fine 1) TEST CH: Center, Low, High
Deviation (3 points)
[Wide] Deviation meter fi lter
LPF: 3kHz
HPF: OFF
PTT: ON
[Narrow] 2) TEST CH: Center
PTT: ON
7. DQT Fine 1) TEST CH: Center, Low, High
Deviation (3 points)
[Wide] Deviation meter fi lter
LPF: 3kHz
HPF: OFF
PTT: ON
[Narrow] 2) TEST CH: Center
PTT: ON
8. DTMF Fine 1) TEST CH: Center
Deviation Deviation meter fi lter
[Wide] LPF: 15kHz
HPF: OFF
PTT: ON
[Narrow] 2) TEST CH: Center
PTT: ON
9. MSK Fine 1) TEST CH: Center
Deviation Deviation meter fi lter
[Wide] LPF: 15kHz
HPF: OFF
PTT: ON
[Narrow] 2) TEST CH: Center
PTT: ON
Receiver Section
Item Condition
1. BPF Wave 1) Center frequency
Adjust Spectrum analyzer setting
AK,AP,UK, Center-f: 470MHz
AM,BM Span: 200MHz
RBW: 100kHz
VBW: 10kHz
ATT: 10dB
2) High-edge frequency
Spectrum analyzer setting
Center-f: 490MHz
3) Low-edge frequency
Spectrum analyzer setting
Center-f: 450MHz
30
U /3306
( )
ADJUSTMENT
Measurement
Test-
Unit
equipment
Power
meter
Deviation
meter
Oscilloscope
AG
AF VTVM
Measurement
Test-
Unit
equipment
SSG
Spectrum TX-RX
analyzer
Adjustment
Terminal Unit Parts
ANT FPU 0.75kHz
SP/MIC
connector
0.38kHz
0.75kHz
0.38kHz
3.0kHz
1.5kHz
3.0kHz
1.5kHz
AK: TK-3302 K AP: TK-3302 P UK: TK-3302(U) K
AM: TK-3302 M BM: TK-3306 M BM3: TK-3306 M3
Adjustment
Terminal Unit Parts
ANT FPU Adjust the waveform
as shown to the Fig.
BPF 1~3.
Specifi cations / Remarks
Method
±40Hz
±40Hz
±40Hz
±40Hz
±100Hz
±100Hz
±100Hz
±100Hz
Specifi cations / Remarks
Method