System Set-Up; Realignment - Kenwood TK-3302 Service Manual

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
Delivery
1. Modes
User mode
PC mode
Wireless clone mode
Mode
User mode For normal use.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
Wireless clone Used to transfer programming data from
mode one transceiver to another.

SYSTEM SET-UP

A personal computer, programming interface (KPG-22/22A),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signalling data are
programmed for the transceiver.)
YES
NO
YES
NO

REALIGNMENT

Data programming mode
PC tuning mode
PC test mode
Function
TK-3302/3302
Frequency range (MHz) RF power
TX/RX 450~490 4.0W
TX/RX 400~430 4.0W
KRA-23 or KRA-27
Optional antenna
KMC-17, KMC-21 or KMC-45
Speaker microphone
(Option)
2. How to Enter Each Mode
Mode
User mode
PC mode
Wireless clone mode
3. PC Mode
3-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22/22A, USB adapter
(KCT-53U)) and FPU (programming software).
The programming software can be used with a PC or
compatible. Figure 1 shows the setup of a PC for program-
ming.
3-2. Connection Procedure
1. Connect the transceiver to the personal computer with
the interface cable and USB adapter (when the interface
cable is KPG-22A, the KCT-53U can be used).
U
(
Type
TK-3302: K,M,P
TK-3302(U): K
TK-3306: M
TK-3306: M3
Operation
Power ON
Received commands from PC
[PTT]+[Side2]+Power ON (Two seconds)
/3306
)
3