Zanussi ZWH 7148 P User Manual page 10

• Directly into a drain pipe at a height
of not less than 60 cm and not more than
100 cm.
If your drain hose
looks like this (see
beside) you do not
require the "U"
piece". Just push the
hose firmly in to the
standpipe.
Connections overview
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
In the interest of the environment
The appliance should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river.
10
The end of the drain
hose must always be
ventilated, i.e. the
inside diameter of the
drain pipe must be
larger than the out-
side diameter of the
drain hose. The drain
hose must not be
kinked.
min. 60 cm
max. 100 cm
• Directly to a built-in drain pipe in the
room wall.
The drain hose may be extended to a max-
imum of 4 metres. An additional drain
hose and joining piece is available from your
Local Centre.
max.
100 cm
~max.400 cm
It is essential that these appliances are not
connected to the surface water drainage sys-
tem as this water is discharged directly into a
river or stream and may cause pollution.
min.
60 cm
www.zanussi.com