Table of Contents
Advertisement
2. Disconnect the power cable and the
3. Press inward on the two tabs on the sides of the drive bay to disengage the bracket from the chassis.
4. Slide the drive upward, and remove it from the system.
Removing the Diskette Drive—Small Desktop System
Removing the Diskette Drive—Small Mini-Tower System
5. If the replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure
each rail to the drive.
6. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and tightening all four
screws.
Removing and Replacing the Drive Bracket Rails
Replacing the Diskette Drive—Small Desktop and Small Mini-Tower System
1. Ensure that bracket rails are attached to the new drive.
2. Gently slide the drive into place until the tabs securely click into position.
3. Attach the diskette drive data cable to the back of the diskette drive.
4. Connect the power cable to the power input connector on the drive.
5. If the drive was previously empty,
Attaching Cables to a Diskette Drive—Small Desktop System
diskette drive data cable
from the drive.
remove the front-panel insert
from the front panel.
1 Drive
2 Bracket rails (2)
3 Screws (4)
Advertisement
Table of Contents
