Table of Contents
Advertisement
Removing the Diskette Drive With the Combination Data Cable
l
Diskette Drive With the Strip Cable Diskette Drive With the Combination Data Cable
Removing the Diskette Drive With the Strip Cable
1. Disconnect the diskette-drive cable from the system board.
2. Remove the power cable from the interposer board.
3. Remove or raise the drive by pressing the green tabs on either side of the drive and lifting the drive up.
4. Remove the diskette-drive cable from the diskette drive.
a. Remove the interposer board from the diskette drive by pressing the tab and rotating the interposer board.
Removing the Interposer Board—Small Form-Factor Computer
b. To release the diskette-drive cable from the connector, slide the lever until it is fully extended, and then lift the cable away.
Removing the Diskette-Drive Cable
1 Diskette-drive cable
2 Tab
3 Interposer board
4 System board diskette-drive connector (DSKT)
Advertisement
Table of Contents
