BY AN AUTHORIZED BOSE SERVICE CENTER OR OWNER OF THE BOSE PRODUCT, AND SHALL NOT BE REPRODUCED OR USED FOR ANY OTHER PURPOSE. WARRANTY The Bose SoundTouch Wireless Adapter is covered by a 1-year limited warranty. Warranty is 2 years in Europe.
The connectors are not designed to charge smartphones, tablets, or similar devices. With SoundTouch, you can stream Internet radio, music services, and your musiclibrary. If you have Wi-Fi at home, you’re ready to enjoy your favorite music in any room or outdoor space that you want.
Page 4
PACKAGING PART LIST SoundTouch Wireless Adapter (refer to Figure 1) Item Description Part Number Note Number BAG,FOAM-FILM,5.00X13.00X0.03 363682-0010 CARTON,DC,175 E,9.50X3.50X1.94 363681-0010 Figure 1. Packaging View...
343757-012 SCRIM, RESET BUTTON 374284-0010 Note: The Airplay version Wi-Fi module (item 5) is used in the SoundTouch wireless adapter that ships with the SA-4 amplifier and the SoundTouch Stereo JC music system. Important Note: When replacing the programmed Wi-Fi module PCB (item 5 above), the serial number and country code MUST be set on the replacement board before returning the unit to the customer.
2.3 Disconnect the Bose link cable at J201. Disconnect the ribbon cables and J200 and J300. Note: The Bose link cable is not easily replaceable. It comes as a service part, included with the top housing, pressed in place. 3. Wi-Fi Module PCB Removal 3.1 Perform procedure 1.
SA-4 amplifier, Stereo JC music system bass module or a Lifestyle 1. Tera Term Terminal USB Setup SoundTouch media center in order to provide power to it for the following tests. Tera Term is a terminal emulator and can be downloaded at http://sourceforge.jp/...
Press the <enter> key on your keyboard system bass module or a Lifestyle after each command. You should see an SoundTouch media center in order to provide OK response in the Tera Term dialog box. power to it for the following tests.
Page 32
6.2 Open your device manger and look under Network Adapters. You should see the sys factorydefault <enter> SoundTouch Wi-Fi adapter as an adapter. 4.2 Provide the customer instructions for Directions: On your computer, click on reconnecting their system to their Wi-Fi Start and navigate to Run.
Page 33
1. Setting the Serial Number the response. 1.1 Connect the SoundTouch wireless 3.4 Return to CLI prompt by entering the adapter to a computer as shown in the TAP command “rm /mnt/nv/local_services” and command setup procedure on pages 31 - <enter>.
Page 34
Then type “e” and <enter>. The command line spotty login: should be 2.2 Enter location of demo URL displayed on the computer. “sys configuration DemoAudioURL http:// worldwide.bose.com/downloads/assets/ 5.2 Enter TAP command “root” and <enter>. audio/take5.mp3” The command line should be root@spotty:root#.
Page 35
• Copy the file to a thumb drive. • Rename the file, if needed, to “Update.stu” (note the capital U). • Plug the thumb drive into the SoundTouch wireless adapter. • Connect the unit to power by connecting the Bose link cable to the back of the SoundTouch product while holding down the reset button on the back of the Wi-Fi adapter.
Description of Change Change Driven Pages Level Affected 4/14 Document released at revision 00. Service manual release 5/14 Part number change. Part number chg. 7/14 Updated test procedures Procedure chg. 30-32 4/15 Added new SoundTouch module part Part number chg. numbers...
Page 37
SPECIFICATIONS AND FEATURES SUBJECT TO CHANGE WITHOUT NOTICE Bose Corporation The Mountain Framingham Massachusetts USA 01701 P/N: 360582-SM Rev. 03; 4/2015 (H) http://serviceops.bose.com...