Adjust Handlebar - Performer Goal-26X Assembly Manual

Adjust OSS handlebar
By adjusting stem
To adjust the angle of handlebar, push the raiser forward and turn the backstop screw in or
out. The backstop screw is close to the stem axle. Turing bolt in and out to let handlebar fold
further back or up. Don't turn the screw out so far which will touch the top of stem when folded
back.
By spacer
If the handlebar is too high to hold after you screw in so far. Please take apart the stem first
then take out spacers from fork. There are 2~4 spacers with 1cm in width. The more spacer
you take off the lower handlebar is. Most riders only need to take 2 spacers off and adjust the
backstop screw. Please note that the handlebar should not touch your knees while riding.
Afterward, install the stem and extra spacer you took off then tighten it.
By fork
If you want to cut fork shorter, the cutting distance is based on 1cm (spacer width) and it's
multiple. You can contact with your local bike shop to cut for you, if you are not familiar with
doing that.
By Cutting riser
In case you are still not comfortable with handlebar position, you can cut the raiser shorter.
1. Remove shifter and brake cable
2. Remove the top cap.
3. Loosen the riser clamp.
4. Take off riser from steer tube
5. Pull out riser
6. Cut the riser to the desired length.
7. Reassemble.
- 7-