"Pulsesteam" Function; Ironing Without Steam; Vertical Steam - Siemens slider SL45 Operating Instructions Manual

Hide thumbs Also See for slider SL45:
Table of Contents

Advertisement

Attention:
When ironing on a lower temperature
setting "•".
• If the appliance has variable steam
control (10*), set the variable steam
n
control to its lowest position
• If the appliance does not have
o
variable steam control, press the
steam release button only for a few
seconds at a time when ironing at
lower temperatures.
In both cases, if you find that water
is dripping out of the soleplate, set
the temperature selector (15) to a
higher position (take care that the
garment can be ironed on this heat
temperature setting).
• At the beginning of each use, it is
possible that drops of water will be
r
dispensed alongside steam.
Therefore, it is advisable to try the
iron on the ironing board or a piece
of cloth to start with.
Tip : for better ironing results, iron the
last strokes without steam to dry the
garment.
"pulseSteam"
5
function
This appliance has a special function
for tackling difficult creases.
The "pulseSteam" function helps soften
stubborn garments like jeans or linen
faster.
When the steam release button is
activated, the steam generator will give
three powerful shots of steam so that
the steam reaches even deeper into
the fabrics.
1. Set the temperature selector (15) on
"•••".
2. Press the steam release button (16)
on the bottom of the handle two
times in quick succession (double-
click).
or (model dependent).
Briefly press the steam release
button (17*) on the top of the handle.
t
* Model dependent
Remarks:
• It is possible to stop the shots of
steam by quickly pressing the steam
button again.
• Some water drops may appear when
.
you use the "pulseSteam" function
for the first time.
The water drops will disappear after
you have used the function for some
time.
Ironing without
6
steam
Begin ironing but without pressing the
steam release button.
7

Vertical steam

This can be used to remove creases
from hanging clothes, curtains etc.
Warning!:
• Never direct the steam jet at
garments that are being worn.
• Never aim the steam at people or
animals.
1.Set the temperature control knob to
at least the "•••" position.
2. Hold the iron in an upright position
15 cm away from the garment being
steamed.
3. You can steam iron curtains and
hanging garments (jackets, suits,
coats...) by placing the iron in a
vertical position and pressing the
steam release button (16 or 17*).
15 cm
9
S IEME NS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents