Siemens slider SL45 Operating Instructions Manual page 17

Problem
Water spots
appear on the
garment during
ironing.
Water spots
p
appear on the
garment during
use of the
"pulseSteam"
function.
The hose gets hot
during use.
Water leakage
from the boiler.
The iron does not
stop steaming
after placing it on
the pad (2).
l
If the above does not solve the problem, get in touch with an authorised technical
.
service.
o
or
You can download this manual from the local homepages of Siemens.
t * Model dependent
Possible causes
• May be caused by steam
condensed on the ironing
board.
• Water spots are caused by
steam condensation in the
hose when cooling down
after use.
• This is normal. It is caused
by the steam passing
through the hose during
steam ironing.
• Filter (4) located at the side
of the appliance is loose.
• "pulseSteam" function has
been activated by double
click.
Solution
• Wipe the textile cover of the
ironing board, and iron any
water drops to dry them.
• Water drops stop coming
out of the soleplate after
using the "pulseSteam"
function for some time.
• Place the hose on the
opposite side so that you
cannot touch the hose
during ironing.
• Tighten up the filter.
• Just press the trigger once
again and the iron will stop
steaming at once.
S IEME NS
17