AEG LAVATHERM 86580IH User Manual page 14

14 www.aeg.com
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each dry-
ing cycle.
• Clean the heat exchanger filters when
the applicable indicator comes into
the view on the control panel.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time 2 buttons (see
the illustration). Hold down until one
of the symbols come into view on
the display:
–
cm
–
300-600 μS/cm
–
μS/cm
3. Push the button again and again un-
til you set necessary level (see the il-
lustration).
low conductivity <300 μS/
moderate conductivity
high conductivity >600
4. To memorise the setting push at the
same time 2 buttons as are specified
in the point 2.
8.3 Water container full —
indication
By default the indication
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the indication can
be off.
To activate or deactivate the indication:
1. Turn the programme dial to availa-
ble programme.
Push at the same time 2 buttons (see
2.
the illustration) and hold down until
you see the correct setting:
– the indication
dicator
view — the indication
manently off
– the indication
dicator
view — the indication
ted
is always on.
is off and the in-
comes into the
is per-
is on and the in-
comes into the
is activa-