Bristol Babcock Network 3000 Setup Manual page 49

Chapter 4 - Guidelines For Configuring the BSAP Data Link
Choice of High Slave Addresses:
One of the first things to be aware of is that if a controller will have more than 1
master port, the range of addresses for each master port's slave nodes must be in
ascending order and MUST NOT OVERLAP.
For example, let's say we
have a 386EX Protected
Mode DPC 3330 which is
a Master to 34 Slave
nodes.
If Ports B, C, and G of
this controller are to be
configured as Master
Ports (see figure, above,
and at right) then the
"High Slave Addr"
parameters for each port
must be configured
properly.
Network 3000 Communications Configuration Guide Page 4-3