Bristol Babcock Network 3000 Setup Manual page 45

Chapter 3 - Guidelines For Setting Up IP Networks
• In the ACCOL load, each IP node must be configured with an IP Port.
• Although the IP address
information is defined in
NetView, the same information
MUST be configured in the
FLASH memory of each
individual RTU, using
LocalView. LocalView is used to
assign an IP address for each
Ethernet IP Port on the IP node,
and to specify the IP address for
the RTU's associated NHP.
Once LocalView has been used to configure this information, the RTU must be
reset (or downloaded with a new ACCOL load) for the new parameters to be
activated. NOTE: For more information on IP address configuration, see
'Chapter 5 - Guidelines For Configuring the IP Data Link'.
Network 3000 Communications Configuration Guide Page 3-17