LG ATNH126ELFC Service Manual page 70

Operation
CST Type Remote controller
3
17
10
11
12
13
14
15
16
18
1. Operation display
Displays the operation conditions.
2. On/Off Button
Operation starts when this button is pressed, and
stops when the button is pressed again.
3. Set Temperature Button
Used to set the temperature when the desired tem-
perature is obtained.
4. FAN Operation Button
Used to circulate room air without cooling or heat-
ing.
5. Fan Speed (Jet Cool Button: 4 way)
Used to set the desired fan speed or select Jet cool
mode.
6. Operation Mode Selection Button
Used to select the operation mode.
• Auto Operation Mode
• Cooling Operation Mode
• Soft Dry Operation Mode
• Heating Operation Mode(except cooling model)
7. Auto Swing Button
Used to swing up and down.
8. Room Temperature Checking Button
Used to check the room temperature.
Display temperature can be different from actual room temperature if the remote controller is installed at
the place where sun-rays are falling directly or the place nearby heat source.
70 Synchro Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater
MED JET Defrost
LO Filter
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
01 03 05 07 09 11 13 15 17 19 21
Set no. Time
Timer Cancel
Program Week Holiday
Plasma
Set/Clr
Hour Min
RESET
Heat Pump Model
1
Preheat
Humidify
Out door
23
6
2
Cooling Model
5
4
7
8
9
9. Plasma Air Clean Button (optional)
10. Timer Cancel Button
Used to cancel the timer.
11. Timer Set Button
Used to set the timer when the desired time is
obtained.
12. Week Button
Used to set a day of the week.
13. Program Button
Used to set the weekly timer.
14. Holiday Button
Used to set a holiday of the week.
15. Time Set Button
Used to set the time of the day and change the
time in the weekly timer Function.
16. Set and Clear Button
Used to set and clear the weekly timer.
17. Swirl Button (4 way)
Used to select swirl mode.
Jet Cool Button (1 way)
18. Reset Button
Used to set the current time and clear the setting
time.